
A charger for your own driveway
The Next Gen wall charger runs at 3.6 to 22 kW on a single-phase or three-phase supply. It is sealed to IP65 for an open carport, comes with a fixed Type 1 or Type 2 cable, and you control it from the app.
Home charging
Plug in when you get home and chargeNET does the rest. It charges at the power you set, at the hours you choose, and shows every session in the app.
Ready
bymorning
Dynamic load balancing
The charger keeps track of how much power the rest of your home is using. When the oven, kettle or air conditioner comes on, it lowers its own draw so the house stays within its supply, then raises it again when they switch off.
Stays within your supply
Charging slows while the house needs the power, so the main breaker isn’t overloaded.
Power you set
Choose the charger’s output in the app, and change it whenever you like.
One charger, set up for your home
Every chargeNET home installation uses the Next Gen Smart Charger. Try the choices below and the charger changes with them. We confirm the right ones for your home at the free site survey.

About43 kmof range added per hour
Your Next Gen
7.2 kW, single-phase, Type 2 cable, with display
Book a home survey
Tell us where you live. An engineer will call to look at your distribution board, usually from a few photos, and confirm the right charger and installation for your home.
Standard installation includes
Surge protection
A surge protection device (SPD) guards the charger against voltage spikes and lightning.
Its own circuit breaker
A double-pole RCBO for the charger alone, so a fault there doesn’t trip the rest of the house.
Cabling and mounting
Up to 10 metres of armoured cable from your board, the wall bracket, and setting up the charger and the app.
